:: Home :: :: Dealers :: :: Labor Rates :: :: Winners :: :: Links ::  SHOP ONLINE NOW!
:: PRODUCTS ::
Racing Shocks
:: Black Magic Shocks
:: Super Shox
:: Adjustable Shock
:: Shock Covers
:: Racing Shocks Setup
Weight Jacker
:: Original Weight Jacker
:: Mini-me Bar Jac-R
:: Big Boy Jacker
:: Bar Car Jacker
:: Indy Jacker
:: Spring Bar Jacker
:: Midget Jacker
:: Penske Adaptor
Chassis Setup Tools
:: Chassis Link 2000
:: Plates
Installation Guides
Goodridge FIttings

:: Seminars ::
:: Motorsports

:: Technical Information::

:: Mini-Me Bar Jacker Installation


SHADOW RACING PRODUCTS
973.684.7270
www.shadowracing.com

EMERGENCY HELP CELL# 973.951.5135

Congratulations! You have just purchased the only torsion bar weight jacker on the market. Our unit is now covered by 2 patents for the USA and Canada.

Please follow these simple steps.

  1. Locate place for master cylinder mount. Holes on master are 1.875" on center and are a 1/4" course thread.
  2. Remove your old torsion stop. While you're doing this, there is some guy in your shop cranking the master cylinder knob on your new unit, tell him to PUT IT DOWN!!
  3. UNIT COMES FULLY COLLAPSED! BUT, if that guy messed with it, you will have to back out knob on master till it stops. Take C-clamp and compress pin until it stops.
  4. Take Bar Jac-R (with stop attached), place on torsion bar splines, tighten 3/8" stop bolt as you would normally...real freakin' tight!
  5. Make your gross block adjustments as you normally would by turning the Jac-R unit itself.
  6. This unit is equal to 1 full turn on your normal torsion stop bolt in total. Three (3) full turns on the knob is equal to one full turn on your stock stop. 15 full turns takes you to the max of travel. The pin travels 1/4" total, which is more than enough adjustment. If you need more adjustment than that....try knitting for a hobby!!

Most of us that race are doing this stuff at midnight! I hope our instructions have lightened up your night in the race shop!

GOOD LUCK AT THE RACES!

-SHADOW

CAUTION!
DO NOT DISCONNECT LINE TO RUN THROUGH BODY WORK!!

DO NOT USE PRESSURE WASHER ON ANY PART OF UNIT!!

KEEP MASTER THREADS LUBED WITH WHITE GREASE!

Please call your dealer for replacement parts!

 

 

Copyright ©2010 Shadow Racing Products